When Quality Counts, Count on Tools Plus

HIGH QUALITY USA MADE

• Tank - 10" x 25"

• Overall Ht. - 37"

• Approx. shipping wt. - 70 lbs.

• Suggested minimum air 7 CFM and 80 PSI

• Maximum pressure 125 PSI

• Automatic shut-off if handle is dropped

• Full control at nozzle handle

• System shuts off at the tank

EC90RC                 $ 1095                  add to basket

Ceramic Nozzles
(5 Piece Set)   $35   add to basket

Rust removal made easy using the Pressure Blaster.  You will be delighted to see how easy it is to remove rust, paint, dirt, and corrosion.  You can do it yourself for less than $10 per hour, and avoid paying others the usual $35 to $50 per hour!  Pressure fed abrasive blasters require less air and abrasive than siphon-type blasters.  And they do a better job.  Using a 2 hp. compressor and the 3/32" nozzle, you can blast an area of approximately 8 sq. inches per minute.  With the 1/8" nozzle and 5 hp. compressor you will clean approximately 12 sq. inches per minute.   

Standard Features: EC90RC

• ASME code tank - certified quality

• 90 lb. abrasive capacity- 30 to 50 min. blast time

• 10 ft. of heavy duty 1/2" ID abrasive resistant hose

• Pull up closure plug - convenient low cost operation

• Adjustable abrasive flow valve

• (5) Ceramic nozzles

• Pressure regulator and water filter with gauge

• Pressure relief valve and pressure relieving ball valve to meet OSHA requirements

• Steel body abrasive flow valve

• Light duty blast hood with bump cap

• Tall vertical tank design

• Remote blast control